SEAT BELT INSTALLATION INSTRUCTIONS

**During installation DO NOT pry on seat tabs - they will break!*** 

1.   DIP SEAT BELT LOOP ENDS INTO A CUP OF HOT (NOT BOILING) WATER FOR A FEW SECONDS.

2.   FOLD THE INSIDE EDGES OF THE LOOP TOGETHER- OUTWARDS.

3.   INSERT THE FOLDED EDGES OF THE LOOP INTO THE SLOT ON THE SIDE OF THE SEAT TOWER

4.   APPLY PRESSURE WITH THE PALM OF ONE HAND ON THE OUTSIDE OF THE LOOP.

5.   WITH THE OTHER HAND, IN A CIRCULAR MOTION, THREAD THE FOLDED EDGES THROUGH THE SLOT.

NOTE:

·       DECIDE WHICH WAY YOU PREFER TO TIGHTEN YOUR  BELT BEFORE INSTALLATION (LEFT OR RIGHT)

·       MAKE SURE THERE ARE NO TWISTS IN THE BELT BEFORE INSTALLATION.

·       INSTALL SEAT BELT BEFORE INSTALLING SEAT PAD.